Preparation For Work - Dnipro M Sr-210 Rx Betriebsanleitung

Protection class
against electric
shock
Degree of
protection against
dust and water
Weight
Value of the noise level according to
EN 62841–2–11
L - sound
pA
pressure level
К - uncertainty
pA
of the sound
pressure level
L - sound
WA
power level
K - uncertainty
WA
of the sound
power level
Vibration level values according to EN
62841–2–11
а - average
h,B
vibration level
(wood cutting)
K - uncertainty of
the vibration level
а
h,B
а - average
h,M
vibration level
(metal cutting)
К - uncertainty of
the vibration level
а
h,M
WARNING!
The parameters are given for a nom-
inal voltage of 230 V and a frequen-
cy of 50 Hz. Different parameters
may apply for other voltage or fre-
quency values.
The information regarding noise
and vibration
The declared overall noise and vibra-
tion values were measured according to
the standard test method defined in EN
62841-2-11 and can be used to compare
one power tool with another.
The declared overall noise and vibration
EU-SR1123001-1123001
II
IP X0
kg 4.5
dB (A) 87.6
dB (A) 3
dB (A) 98.6
dB (A) 3
m/s² 17.2
m/s² 1.5
m/s² 17.45
m/s² 1.5
levels can be used for preliminary assess-
ments of noise and vibration exposure..
WA R NI NG!
The transmission of vibration and
the emission of noise during the use
of the power tool may differ from
the declared values depending on
how the tool is used, especially the
type of material being processed.
The declared level of noise and vibration
applies to the tasks for which the power
tool is intended.
WA R NI NG!
Use personal protective equipment
in accordance with the working
conditions.

7. PREPARATION FOR WORK

WA R NI NG!
Before preparing for work, during
servicing, and
work with the power tool, unplug it
from the socket.
If you have stored or transported the
power tool at a temperature lower than
the one at which it is intended to be
used, make sure that there is no conden-
sation on the power tool. If condensation
has formed on the power tool, its further
preparation for work or operation is pro-
hibited until the condensation has com-
pletely dried.
Installing the saw blade (Fig. 2)
WA R NI NG!
When installing the saw blade, use
protective gloves. Do not use a
damaged saw blade as it increases
the risk to the user and may cause
damage to the power tool.
Rotate the blade fixing lever (1) and in-
sert the saw blade into the holder until it
stops. Release the blade fixing lever to its
initial position and check the secure fas-
tening of the saw blade in the holder.
after completing
en
7