Silvercrest STEC 920 A1 Kurzanleitung Seite 12

Crisping bread rolls
Never lay bread rolls directly onto the toaster, always use the bread roll rack 6.
1) Fold out the two feet of the bread roll rack 6.
2) Place the bread roll rack 6 onto the appliance so that the feet protrude into
the toasting slots 7 and the bar between the toasting slots 7 fits into the
arched sections on the feet. In this position, the bread roll rack 6 sits on the
appliance stably.
3) Place the bread rolls onto the rack and start the toasting procedure. Set the
toasting dial 2 to the desired browning level. We recommend setting the
browning level to 1, but the setting may vary depending on the bread type
and personal taste.
NOTICE
► After toasting, the rolls will be very hot.
4) As soon as the toaster switches itself off, turn the rolls over to crisp the other
side and then switch the toaster back on.
5) When you are finished with the bread roll rack 6, you can fold it for
space-saving storage:
–
Wait until the bread roll rack 6 has cooled down.
–
Remove it from the appliance.
–
Fold the feet of the bread roll rack 6 back in.
Disposal
Do not dispose of the appliance in your normal domestic waste.
This product is subject to the provisions of European Directive
2012/19/EU (Waste Electrical and Electronic Equipment).
Dispose of the appliance through an approved disposal centre or at your
community waste facility. Observe the currently applicable regulations. In case
of doubt, please contact your waste disposal centre.
Your local community or municipal authorities can provide information on how
to dispose of the worn-out appliance.
The product is recyclable, subject to extended producer responsibility and is
collected separately.
STEC 920 A1
GB │ IE │
9 ■