NEC MultiSync FE1250+ Bedienungsanleitung Seite 10

Controls
–continued
IPM ™ System Off Mode:
NOTE: For standard systems and graphics boards, keep the factory setting
at ENABLE
EdgeLock Control: Operating your monitor at a non-standard timing may
™
cause images to appear darker than normal or have color distortion. Use of the
EdgeLock control will adjust images to their normal state.
Information
Display Mode: Indicates the current mode and frequency setting of the monitor.
Monitor Info: Indicates the model and serial numbers of your monitor.
Refresh Notifier: A message will advise you if the refresh rate of the signal being
applied to the monitor by the computer is too low. For further information, please
refer to your display card or system manual.
FE1250Plus.wpc
Enable: The IPM System works normally and all
stages of energy savings are utilized.
Disable: The Off Mode of the IPM System is not used.
8
10 12/6/00, 10:32 AM