Optionally: Adding Targets - G&D Remoteaccess Installationsanleitung

Optionally: Adding targets

NOTE: This paragraph refers to targets accessible via
Detailed information on how to add
manual.
How to add targets:
1. In the left corner, click on
2. Click on
RA-Workplace Configuration
NOTE: You can also open the configuration window by pressing the key combi-
nation Ctrl+Alt+C
3. Click on .
Targets
4. Click on .
New
5. Enter the following data to connect a target:
TARGET
Type:
NETWORK CONNECTION
IP Address/Hostname:
Port Number:
6. Click on .
Save
7. Click on .
Back
8. Repeat steps 4 to 7 to add more targets.
HTML
Main Menu .
.
.
Select whether you want to access the target via
VNC or SSH protocol.
Enter the IPv4/IPv6 address or hostname of the target.
Enter the port number of the target.
RDP VNC or
,
or targets is given in the operating
ESXi
G&D RemoteAccess-Workplace · 11
Getting started
SSH protocol.
RDP
,