Configuring The Network - G&D Remoteaccess Installationsanleitung

Configuring the network

NOTE: When integrating the
DHCP server, the network settings are assigned automatically.
In this case, continue with the next paragraph Adding »RemoteAccess-GATE« add-ons
on page 10.
How to configure the basic network settings:
1. In the left corner, click on
2. Click on System Settings > Network
3. Select the interface you want to configure (
4. Click on the tab
IPv4 Settings
5. In the field, select one of the following options:
Method
Automatic (DHCP):
Automatic (DHCP),
addresses only:
Manual:
Disabled:
6. If you have selected the
the table:
Address:
Netmask:
Gateway:
7. Click on OK .
NOTE: This paragraph describes only the basic network configuration for the suc-
cessful start-up of the device.
Detailed information on this topic is given in the operating manual.
RemoteAccess-Workplace
Main Menu .
.
Ethernet 1
.
The DHCP server automatically assigns an IPv4 address
and the DNS server(s) (default).
The DHCP server assigns only the IPv4 address
automatically.
The interface uses static network settings configured by
the user.
The IPv4 network connection is disabled.
Manual setting, click
IPv4 address of the interface selected
Netmask of the network
IP address of the gateway
add-on into a network with
or Ethernet 2 ), and click on
Add and enter the following data in
G&D RemoteAccess-Workplace · 9
Getting started
Edit .