Interfaces On The Back Panel - G&D Remoteaccess Installationsanleitung

Interfaces on the back panel

DC IN HDMI
DC IN: Plug the connection cable of the supplied table power pack into this interface.
Connect the table power pack to a mains socket.
NOTE: The device provides one
three monitors to the device.
If required, connect a monitor.
HDMI:
DP: If required, connect one or two monitors.
LAN ( ): Plug a twisted pair cable, available as an accessory, into at least one inter-
face. Connect the other end of the cable to a gigabit network.
USB 3.1 Gen 2 ( ):
USB 3.1 Gen 1 (
NOTE: The interfaces are reserved for future functions and currently have no
COM
function.
DP DP
and two
HDMI
Connect any USB devices to these interfaces.
Connect any USB devices to these interfaces.
):
COM1 COM1 COM2 COM2
interfaces. You can connect up to
DP
G&D RemoteAccess-Workplace · 5
Installation