LANCOM 800+ Installationsanleitung Seite 25

LANCOM Routers, WLAN routers, access points and WLAN controllers
I
... via the serial interface
I
... via Dial- Up Networking/ISDN connection (remote
configuration)
... via the wireless network (WLAN)
For LANCOM
wireless routers and
LANCOM access
I
points only
The MAC address on a sticker on the base of the device.
If there is no DNS server in the LAN, or if it is not coupled to the DHCP
server, the device cannot be reached via the name. In this case the
following options remain:
Use suitable tools to find out the IP address assigned to the LANCOM
by DHCP and access the device directly using this IP address.
Using LANconfig.
Use the serial configuration interface to connect a computer running
a terminal program to the device.
If it is not possible to establish LAN access to the device, computers can
be connected via the
configuration is carried out with
For outbound configuration via a terminal program, it is not possible
to use any of the Setup wizards. The most convenient option here is
to use LANconfig.
If your device is at a remote location and accessible via ISDN, you can
carry out a remote configuration with LANconfig. For further information
on remote configuration
Ex-factory, WPA encryption is activated for every unconfigured
LANCOM wireless router as standard. For WLAN devices being
managed by a LANCOM WLAN Controller, encryption settings are
overwritten by the central encryption settings in the profiles of the
WLAN Controller.
If your device has one or more WLAN interfaces, you can also carry out the
configuration via wireless.
LANCOM wireless
WLAN to carry out a wireless configuration requires the use of the
preshared key (PSK) for the standard WPA encryption.
serial configuration
LANconfig
refer to the Reference Manual.
router: Connecting to a new LANCOM router via
First Steps
interface. In this situation,
or a terminal program.
8