LANCOM 800+ Installationsanleitung Seite 21

LANCOM Routers, WLAN routers, access points and WLAN controllers
Searching for and configuring the device...
A LANCOM router, wireless router, access point or WLAN Controller can be
configured over the following paths (assuming that the model is equipped
with the corresponding interface).
I
For LANCOM
wireless routers
only
in the LANCOM (default = on). Contradictory settings can lead to data
transfer errors, either immediately or after some time (days).
Connect the device to the power supply
adapter unit or power cord) and switch on the power switch.
If your network contains a LANCOM WLAN Controller, then the
network commissioning of access points is generally fully automatic.
For further information please refer to the manual "Central WLAN
Management".
Via the local network (LAN) ³.
Via the wireless LAN
·
deactivated) in the configuration computer and the device with the
wireless interface.
As of LCOS version 7.22 all LANCOM access points are set to "Managed
Mode" when shipped, and the WLAN modules are switched off. For this
reason the first-time configuration of LANCOM access points via WLAN is
not possible.
Via the serial configuration interface ».
Via an ISDN connection ¿.
LAN
ROUTER ACCESS POINT
1
if WLAN encryption has been correctly set up (or
LAPTOP PC
Outband
ROUTER
2 3
First Steps
(via the supplied power
PC
ISDN
ROUTER
4
4