Matrix RT 500-1 Originalbetriebsanleitung Seite 15

When working outside, the power outlet must
be equipped with a fault current safety switch.
Pull the plug when not using the machine or
while setting up the machine.
Always lead the cord away to the back of the
tool.
Check the connector cable regularly for signs
of age and other damage. If its condition is not
good the machine must not be used.
Before connecting the machine to the mains,
check the line reel, line cover and the on/off
switch for damages.
Use the machine only in an undamaged
condition.
Before beginning work, it is recommended
that you check the area to be cut for possible
foreign objects and to remove them. However,
if you do hit a foreign object, turn the machine
off and remove the object.
If foreign objects (stone, accumulation of
grass) cause a blockage, turn the machine off
and remove them with a blunt object. Never
remove blocked foreign objects with your
fingers as this can result in serious injury.
When the machine is running, it must be kept
away from your body without exception.
Never turn the machine on without it being in
the work position.
Always turn the machine off, wait until the
rotating line has come to a standstill and unplug
the cord when the machine is not in use, when
checking it, when it is unattended, when you
change the line reel or when it is being
transported from one location to another.
After use, unplug the cord and check the
machine for any damage.
Caution: The line continues to rotate after the
machine has been switched off! Never touch
the cutting line when the machine is running.
Do not overload the machine and do not do any
work for which the machine is not designed.
Make sure that the air intakes are always free
of dirt.
Store the machine out of the reach of children.
Store the machine in a safe and dry location.
Use only accessories recommended by the
manufacturer.
Always use only the original line. Never use a
metal wire instead of the nylon line.
The machine and the line reel must be checked
and maintained regularly and properly.
Damages must be repaired by a professional
workshop.
Damaged line reels must be replaced
immediately.
Check the power cord regularly for damage
and signs of wear and tear. The power cord
may only be used in a damage-free condition.
Keep power cords away from the cutting area.
In the case of damage to the power cord during
operation, turn the machine off and unplug the
cord. Do not touch the power cord before it is
unplugged.
Check that all screws and connecting parts are
firmly in place.
Always hold the machine firmly with both
hands.
Keep limbs and clothing away from the line
head when you start the motor or when it is
running.
Keep the machine far away from other persons,
especially children and also animals.
15