Environmental Requirements - Ipro Inverter Smart Flow S Betriebsanleitung

• Maintenance may be commenced no sooner than 5 minutes after the electric
power supply has been switched off, when all the control LEDs have gone out.
Risk of electric shock.
• Do not touch any parts in the electrical system with bare hands when the device
is connected to the electric power supply. Risk of electric shock.
• Sub-assemblies or components may only be replaced by an authorised service
centre.
• Any metal items must not be left in the device. Risk of electric shock or fire.
CAUTION
• Bare components of the electronic system must be protected with insulating tape.
Risk of electric shock.
• Do not install or operate the inverter if it is damaged or any of its components are
missing. Risk of fire or electric shock to the operator.
• When installing the inverter, check whether the installation site is strong enough
to bear its weight. The inverter may drop down and damage the property or cause
injuries.
• nstall the inverter in such a manner that any leakage in the system does not cause
flooding of the device with water. The inverter must be protected from water,
including precipitation. The inverter must not be installed in rooms exposed to
high air humidity. Risk of damage to property.
• Install the inverter away from direct sunlight. UV light increases the risk of damage
to property.
• The inverter must be installed and stored at room temperature, in a dry, cool and
well-ventilated place.
• At high temperatures or in summer, good ventilation is required to avoid conden-
sation and dew. Risk of damage to property.
• Maintenance work on the inverter may only be performed by a professional.
• Secure the inverter after it has been installed. Limit access so that the inverter is
inaccessible to children.
3.

ENVIRONMENTAL REQUIREMENTS

External conditions directly affect the operation and reliability of the device. Therefore, the
following conditions must be met:
• Permissible ambient temperature range: from: od 0°C do +40°C
• The device can be used only indoors
• Install away from corrosive substances and explosive gases
CAUTION
20