Shott CF2000 Bedienungsanleitung Seite 16

E N
9. Troubleshooting.
P
ROBLEM
The product does not work.
The product does not work.
The product does not work.
Power cord damaged.
Plastic components damaged.
Low flowrate from outlet
Low flowrate from outlet
Low flowrate from outlet
Low flowrate from outlet
The product does not work.
The product does not work.
The product does not work.
The product does not work.
The product does not work.
Power cord damaged.
Damaged rotor and/or bearing plastic
components.
Water leak.
Water leak.
Blocked rotor.
Cleaning cycles needed more and more
closer.
Water flow at filter outlet insufficient.
10. Retail and spare parts and relevant documentation.
See Tab. 2 with reference to Fig. 16.
Replace any damaged and/or worn components as quickly as possible; use only original spare parts.
Nome file:
7521002 - ISTRUZIONI FILTRO A CARTUCCIA.docx
File name:
C
AUSE
No or insufficient power supply.
The power plug is not correctly inserted in
the power outlet.
Hydraulic components clogged or bent.
Wear and/or negligence.
Wear.
The product is dirty
Hydraulic components clogged or bent.
The impeller's blades are worn out.
The product is not trimmer correctly.
The thermal protector has been triggered.
The thermal protector has been triggered.
The impeller and/or rotor are blocked by
dirt.
The rotor and/or bearing are worn out.
The impeller's blades are worn out.
Wear and/or negligence.
Wear.
Gaskets or o-rings incorrectly installed
Fast connections or cover not tight.
Foreign bodies block the rotating elements
of the product (impeller or cooling fan).
Presence of seaweeds.
Blocked filter.
ST
1 S
OLUTION
Check the power supply.
Firmly insert the power plug in the power
outlet.
Clean and adjust hydraulic components.
Contact specialised technicians.
Replace.
Clean the product.
Clean and adjust hydraulic components.
Replace the rotor.
Trime the product like illustrated in Fig. 15.
Check that the water temperature does not
exceed +35 [°C] and, if necessary, add
cold water to the pool to lower water
temperature.
Blocked drive shaft, follow the instructions
in blocked rotor.
Clean the product.
Replace the rotor and bearing
Replace the rotor
Dispose of the product.
Replace the rotor and bearing.
Check correct gasket and o-ring
installation.
Tighten fast connections and cover..
Remove any foreign bodies.
Check the eventual presence of seaweeds
in the pool and if needed add a disinfectant
or a PH level corrective.
Filter cleaning.
Tab. 7
16-32
ND
2 S
OLUTION
Contact specialised technicians.
Contact specialised technicians.
Contact specialised technicians.
-
Contact specialised technicians.
Contact specialised technicians.
Contact specialised technicians.
Contact specialised technicians.
Contact specialised technicians.
Contact specialised technicians.
Contact specialised technicians.
Contact specialised technicians.
Contact specialised technicians.
Contact specialised technicians.
-
Contact specialised technicians.
Contact specialised technicians.
Contact specialised technicians.
Contact specialised technicians.
Contact specialised technicians.
Cleaning the filter media.
Rev. 1 26/09/2014