miniland digitalk easy Bedienungsanleitung Seite 17

ENGLISH
1) Zero emissions mode (ZERO)
Setting:
When both units (the parents´ and the baby´s) are turned on the On/Off and charge LED
indicator (4) on the parent unit will light up in orange to show the ZERO mode has been selected.
To activate this mode you have to make 3 short presses on the ON / OFF button (1) of the
parents' unit.
Operation:
During normal baby monitor operations (LOW) the baby unit sends a regular beacon signal to
the parent unit informing that it is connected and operating, even when the baby unit does not
detect any sound.
However, you may select the ZERO operating mode, which does not emit this beacon signal,
thereby reducing emissions to zero while the baby monitor is in standby mode. When the baby
unit detects no sound in the room the average will be zero emissions, whereby the baby monitor
will not emit any radiation whatsoever.
When the baby unit detects a sound above the VOX sensitivity threshold (pre-established), it will
begin to emit a signal to the parent unit as a means of establishing communication between the
two units. This process will last for less than one second.
From this moment on the parent unit will retransmit the sounds captured by the baby unit.
N.B: Out of range indicator
Due to the fact the baby unit does not emit the regular beacon signal when the device is in
the "ZERO" mode, the parent unit is incapable of detecting whether it is within the range
of the signal or not. As such, the parent unit may be out of the range of the signal of the
baby unit without the parents being aware of the fact.
We recommend using this mode of operation when the parent unit is in a fixed position
which has been checked beforehand for range of coverage, such as on the bedside table.
It may also be used by moving the parent unit, whenever it has been checked beforehand
that signal is available throughout the radius of movement.
2) Normal operating or low radiation mode (LOW)
Setting:
To activate this mode you have to make 3 short presses on the ON / OFF button (1) of the
parents' unit.
Operation:
As explained previously, during normal baby monitor operations (LOW) the baby unit sends a
regular beacon signal to the parent unit informing that it is connected and operating, even when
the baby unit does not detect any sound. This signal lasts for 1 second and is emitted 4 times
every 20 seconds. If the parent unit receives this signal the On/Off and charge LED indicator (4)
lights up green to show that the unit is within the signal range. On the contrary, if the parent unit is
incapable of receiving the beacon signal after 20 seconds, the On/Off and charge LED indicator
(4) will flash red and green alternately emitting a three-tone warning beep.
On selecting the "LOW" mode a continuous low-power connection is established between the
parent and baby units, reason for which there is no delay in the connection indicated for the
"ZERO" mode when the baby unit detects a sound while in standby mode.
5.2.7. Out of range alert
If the connection between the parent unit and the baby unit is lost at any time, the two sound level
indicators on the parent unit will flash alternately in red for 20 seconds to show it is searching for
17