•
Unplug the coffee maker before cleaning or when you
are not using it.
•
When unplugging the unit, pull the plug but not the cord.
•
It is forbidden to turn off the unit and disconnect it from
the mains during the process of preparing drinks and
cleaning the system.
•
For child safety reasons do not leave polyethylene bags,
used as packaging, unattended.
Attention! Do not allow children to play with polyethylene
bags or packaging film. Danger of suffocation!
•
This unit is not intended for usage by children.
•
Place the unit out of reach of children during the opera-
tion and cooling down.
•
Do not allow children to touch the unit and the power cord
during the unit operation.
•
The unit is not intended to be used by people (including
children) with any physical, sensory or mental disabilities
or by persons lacking life experience or knowledge if they
are not under supervision of a person who is responsible
for their safety or if they are not instructed by this person
on the usage of the unit.
•
Do not leave children unattended to avoid them using
the unit as a toy.
•
Do not use the unit if the coffee maker body, the power
cord or the power plug is damaged.
•
To avoid leakage to the electrical connector, if any mal-
functions occur, or if the device is dropped, turn the
device off from the mains socket and contact any autho-
rized service center.
•
If the power cord is damaged, it must be replaced by the
manufacturer, service department or similar qualified
personnel to avoid potential injuries.
•
In order to avoid potential injuries, it is forbidden to
repair the device yourself. Do not disassemble the unit
by yourself, if any malfunction is detected or after it
was dropped, unplug the unit and apply to any autho-
rized service center from the contact address list
given in the warranty certificate and on the website
www.rondell.ru.
•
Transport the unit in the original packaging only.
•
Keep the unit in a dry cool place out of reach of children
and disabled persons.
THIS UNIT IS INTENDED FOR HOUSEHOLD USE ONLY.
COMMERCIAL USAGE AND USAGE IN PRODUCTION AR-
EAS AND WORK SPACES IS PROHIBITED.
BEFORE THE FIRST USE
After unit transportation or storage at low temperature
keep it for at least three hours at room temperature be-
fore switching on.
– Take the coffee maker out of the package and remove the
packaging materials.
– Check the unit for damage, do not use it if it is damaged.
– Make sure that operating voltage of the coffee maker cor-
responds to the voltage of your mains.
– Before the first use, it is necessary to remove the protec-
tive silicone plug from the water supply valve (17) at the
bottom of the tank (2).
– Before using the coffee maker for the first time, rinse
all its removable parts (2, 6, 8, 12, 14, 15, 16) with warm
water using a neutral detergent and dry them.
OPERATION PREPARATION
Notes:
– the operation mode selection and setting buttons are
sensory, you just need to touch the button to switch the
necessary operation mode on, every touch of the active
button is accompanied by a sound signal.
– if you switch the coffee maker on and don't do anything,
you will hear sound signals and the coffee maker will be
switched off in 25 minutes.
Before brewing coffee, it is necessary to rinse the boiler of
the coffee maker:
•
Remove the water tank (2), fill it with cold water up to the
«MAX» mark and install it back to its place.
Notes: Only clean water at room temperature can be
poured into the tank (2). Do not fill it with hot or ice water
and milk. Failure to comply with this requirement will cause
the tank to crack and damage the unit.
•
Install the filter (14 or 15) in the holder (12) matching the
ledge on the filter with the slot in the holder, turn the fil-
ter to lock. Do not add ground coffee into the filter
•
Install the filter holder (12) in the place where it is
installed on the coffee maker. The filter holder (12)
ledges should match the groves on the boiler, after
that turn the filter holder (9) handle to the utmost right
position.
Note: To facilitate the installation of the filter holder, the
appropriate symbols are applied on the front panel of the
coffee maker.
•
Place a suitable cup on the tray grid (6).
•
Insert the power plug into the socket.
12