RONDELL RDE-1106 Betriebsanweisung Seite 11

COFFEE MAKER RDE-1106
Coffee maker is intended for making: «Espresso», «Lungo»,
«Cappuccino», «Latte» and hot water.
DESCRIPTION
1. Water tank lid
2. Water tank
3. Steam supply control handle
4. Cappuccinator pipe
5. Removable tip
6. Drip tray
7. Drip tray fill indicator
8. Drip tray grid
9. Filter holder handle
10. Control panel
11. Cup warming tray
12. Coffee filter holder
13. Coffee filter lock
14. Filter for one cup of coffee
15. Filter for two cups of coffee
16. Measuring spoon with tempera function
17. Water tank valve
Control panel (10)
18. ON/OFF button « »
19. Button for making one cup of espresso coffee «
20. Button for making two cups of espresso coffee «
21. Manual water supply mode button «
22. Steam supply on button «
ATTENTION!
For additional safety protection of the power circuit, install-
ing a residual current device (RCD) with the nominal op-
eration current not exceeding 30 mA is recommended. To
install the RCD contact an expert.
OPERATION AND SAFETY RECOMMENDATIONS
Read these instructions carefully before using the unit. Keep
this manual for the entire usage period.
•
Mishandling the unit can lead to its breakage and cause
harm to the user or damage to his/her property.
•
Before switching the unit on for the first time, make sure
that the operating voltage of the coffee maker corre-
sponds to the voltage of your mains.
•
The power cord is equipped with the «europlug»; plug it
into the socket with a reliable grounding contact.
•
•
•
•
•
•
•
•
•
•
•
•
•
»
•
»
»
»
•
•
•
•
•
•
•
•
11
To avoid the risk of fire, do not use adapters for connect-
ing the coffee maker to the mains socket.
Use the coffee maker according to its intended pur-
pose only.
Do not use the unit outdoors.
Never leave or keep the coffee maker in places with the
temperature below 0°C.
Place the coffee maker on a dry flat stable surface; do not
place it on the edge of the table.
Do not place the coffee maker on hot surfaces.
Make sure that the coffee maker does not get direct
sunlight.
Do not use the coffee maker near heat and moisture
sources and near open flame.
When installing the coffee maker, leave 10 cm of free
space on each side of the unit to ensure its effective
cooling.
Do not let the power cord hang from the edge of the table
and make sure it does not touch hot surfaces or sharp
edges of furniture.
Be careful while handling hot water.
To avoid electric shock, do not immerse the coffee maker,
power cord or power plug into water or other liquids.
To avoid injury, do not touch with your hands moving
parts of the unit, such as the coffee grinder or the brew-
ing block, while the unit is in use.
It is forbidden to move the coffee maker or remove the
protective elements (for example, remove the coffee fil-
ter holder (12)) during preparation of drinks and rinsing.
Use only the accessories supplied.
Do not switch the coffee maker on if the water tank is
empty.
Fill the tank with clean water only, it is recommended
to use water additionally cleaned with domestic water
filters.
Before switching the coffee maker on, make sure that all
removable parts are installed properly.
Never leave the operating coffee maker unattended.
Do not touch the power cord, the plug and the coffee
maker body with wet hands.
To avoid burns, do not touch the hot surfaces of the cof-
fee maker (coffee supply unit, boiler) during preparation
of coffee and immediately after turning off the unit. The
surface of the heating element remains hot after use.
Let the unit cool down completely before cleaning it or
removing the accessories.