Update - Jeti Model Duplex Rcsw Bedienungsanleitung

● RCPowerSwitch(RCPS5, RCPS10)
The power supply is connected via a two-wire cable. The positive
poleisswitched,thenegativepoleiscommon.
For switching on constant currents lower than5A, use the RC
PowerSwitch5.
For switching on constant currents lower than 10A be sure to use
theRCPowerSwitch10.
The maximum switching current must not be exceeded, see
chapter „3.Technicaldata".

2.1 Update

The RC Switch allows updating the firmware via PC. Updating is
doneusing theJeti USBadapter.
Procedure:
1. Find the program to update to the latest firmware on the
manufacturer's website under "Downloads". Save it to your
computer.
2. Connect the USB adapter to your computer. The procedure of
installing the drivers for the USB adapter is included in the USB
adaptermanual.
3. Run thefirmwareupdateon your PC.
4. Connect the USBadapter to the RCSwitch (Ext. output) using a
three-wirecable.
5. Přehodit pořádek slov: After connecting the device the update
will begin.
COM PLEX RADIO CONTROL SYSTEM
16
EN