Aegislink S-RF200 Benutzerhandbuch Seite 7

How to Disconnect
Pressthe pinho e pairing button 4 times using the pin and the unit wil
beep once. Then,hold down the pairing button until the unit beeps once
more to disconnect. After disconnecting, it can be reconnected to the
same network, or added to a new network.
Alarm Test
Besure to test your alarms when you turn them on for the first time, or
when the group configuration has changed. n addition to the weekly
tests you should perform, it is recommended to test the alarm after
returning from a ong trip or vacation,
f your AEGISLINK S-RF200/S-RF220/S-RF240/S-RF500 interconnected to
other wireless alarms,we recommend that every individual alarm is
tested during the weekly test
•10 •
Test a Single Alarm
Action Press the
test/silence button,
Indication •The alarm wil beep
3 times every4
seconds,
•The LED will flash
red during the
audible signa
•After testing, the
alarm Will
automatically enter
standby mode.
Test All Interconnected Alarms
Hold down the test/silence button.
•The initiating unit will beep
continuously with the LED
flashing red.
• Other interconnected units in the
network will receive the signa
after 5 seconds,then they wil
beep continuously with the LED
flashing red and green
successivey. Releasethe
test/silence button and all the
units will stop testing.
•The testing ofthe units should be
completed within 3 minutes.
•After testing, the units wil
automatically enter standby
mode.
•11 •