Aegislink S-RF200 Benutzerhandbuch Seite 6

3. After the search is successfuland an interconnected group is created,
both units wil beep once and automatically exit the interconnection
mode. At this point, both units wil on y flash once every60 seconds,
indicating they are in normal standby mode.
4 f you want to connect a third alarm to this group, first activate the new
device according to its operating instructions. Pressthe pinho e pairing
button on either of the 2 previously interconnected units using the
included pin, it will beep once and the LEDwill flash red slowly,
indicating it hasentered pairing mode and is waiting for a new unit to
be added. Hold down the pinho e pairing button on the new unit until
it beeps once and its LEDflashes red rapid y as it searchesfor a network
to which it can connect. After the third unit successfuly joins the
interconnected network, both units will beep once and automatically
exit the interconnection mode.
5. f you want to connect more units, simply repeat step 4. Up to 24
alarms can be interconnected this way. To ensure that all alarms
enter the same interlinked network, make sure you only work
with 2 units at a time—one unit enters the pairing mode and the
other unit enters the searching mode.
6 Test the alarmsaccording to the steps in the section "Alarm Test".
•08 •
Press the
pinhole pairing
buttcm
pinhole pairing button
NOTES
I. Thealarm will enter the searching mode or the pairing mode for 60 secondswith
the LEDflashing red. After 60 seconds,repeat step 2 to connect the alarms. If
needed,pressthe pinhole pairing button once while the alarm is in the searching
mode or the pairing mode, and the LEDwill stop flashing red and the alarm will
quit the pairing mode to enter normal status.
2. Testall wirelessalarms to ensure they are interconnected before installation.
3. A maximum of 24 wireless alarms can
4. Themodel can only beinterconnected with other AEGISLINK wireless interlinked
alarms.
Press the
pinhole pairing button
Hold dom the
pinhole pairing button
the test"silence button
be interconnected on the same network.
• 09 •