Aegislink S-RF200 Benutzerhandbuch Seite 12

Unit that The LED
detected flashes
smoke and
green once
initiated an
alarm, second
seconds.
Test Test a single The LED
flashes red 3
Mode unit.
times every
4 seconds.
Test al The LED
interconnected indicator
units. flashes red
rapidly.
The LED
flashes red
and green
sequentially.
None. Alarm
cancellation:
When the smoke
concentration
evel drops be ow
for 5
the alarm
threshold, the
alarm signal wil
stop. Then,the
alarm goes back
to the standby
mode.
3 quick Press the
beeps every test/silence button
4 seconds.
Continuous nitiating unit,
beeping Hold down
until you test/silence
release the on one unit in the
test/silence network.
button,
Other
interconnected
alarms in the
network
• 20 •
Silence
Low Battery
Malfunction
Alarm
The AEG SLINK wireless interlinked alarms can be interconnected
the
that any unit that sensesdanger will cause all other units in the
button
interconnected
1. If the Initiating
When one smoke alarm is triggered in the interconnected network,
the unit will beep 3 times, paired with the LEDthat flashes red every 4
seconds. Any other interlinked units will follow suit—they will beep 3
times every 4 seconds, paired with the LEDflashing red and green in
succession.
Mode The LED flashes None
red once every 5
seconds.
The LED flashes 1 beep every
red once every 60 seconds.
60 seconds.
The LED flashes 2 beeps every
red twice every 40 seconds.
40 seconds.
Mode
network to alarm.
Unit Is Triggered by Smoke:
•21 •
After 9 minutes,
the unit will exit
silence mode.
Each alarm
gives an
independent
warning
Each alarm
gives an
independent
warning.
such