Battery Replacement - Aegislink S-Rf200 Benutzerhandbuch

A WARNING
I _THIS ALARM SHOULD BE INSTALLED
2. ALARMS SHOULD NOT BE USED AS A SUBSTITUTE
NSTALLATION, USE AND MAINTENANCE OF FUEL BURNING
APPLIANCES INCLUDING APPROPRIATE
SYSTEMS.
3. TO PREVENTINJURY,THIS DEVICESHOULD BE SECURELYATTACHED TO
THE CEILING OR WALL IN ACCORDANCE
NSTRUCTIONS.
4. BATTERIES SHOULD NOT BE EXPOSED TO EXCESSIVE HEAT SUCH AS
DIRECT SUNLIGHT FIRE,ETC
Installation Method
NOTE: Before installation, it is recommended
rooms where you intend to install them to ensure that they are within transmission
range and that nothing will interfere with their communication.
1. use the mounting bracket to mark the screw holes on the ceiling or
the wal
2. Drill holes at the 2 marks using an appropriate y sized dril bit Insert
the anchor plugs and screw the mounting bracket using the screws
provided.
3. Attach the alarm to the mounting bracket and turn clockwise to lock
the alarm.
BY A COMPETENT PERSON.
FOR PROPER
VENTILATION AND EXHAUST
WITH THE INSTALLATION
to test the interconnected alarms in the
•16 •
4 Test the alarm according to the steps in the section "AlarmTest".
Note: Picturesshown are for illustrative purposes only, and may differ from the
a/ pro duct.
Battery Replacement
1.To replace the battery, detach the smoke alarm from the mounting
bracket by twisting counterclockwise.
2. Pull the battery removal tab to remove the battery, and then install a
new battery, matching the correct polarity markings.
3.Test the alarm, and then mount the alarm onto the mounting bracket
by twisting clockwise to lock the alarm.
•17 •