Aegislink S-RF200 Benutzerhandbuch Seite 5

A WARNING
I _ NEVER IGNORE ANY ALARM. FAILURE TO RESPOND
SERIOUS INJURY OR DEATH.
2. THE SILENCE FEATURE IS ONLY FOR YOUR CONVENIENCE
NOT CORRECT A PROBLEM. ALWAYS CHECK YOUR HOME
POTENTIAL PROBLEM AFTER ANY ALARM.
RESULT IN INJURY OR DEATH.
3. TEST THIS SMOKE ALARM ONCE A WEEK. IF THE ALARM
TEST CORRECTLY,REPLACE IT MMEDIATELY! IFTHE ALARM CANNOT
WORK PROPERLY,ITWILL NOT ALERT YOU TO A PROBLEM.
How to Set Up and Interconnect
All AEGISLINKwireIess interlinked
that enab esyou to wirelessly connect 2 or more interlinked alarmsand
create an interlinked network. When one unit is triggered, al
interconnected alarms will sound.
interlinked smoke alarms, wireless interlinked
and wireless interlinked combination
alarms.This model is designed to be wirelessly interlinked with other
AEGISLINK alarms, but is not designed to communicate with wireless
interlinked alarms from other manufacturers.
CAN RESULT IN
AND WILL
FOR A
FAILURE TO DO SO CAN
EVER FAILS TO
Wireless Alarms
alarms contain a built-in RF module
The AEGISLINK series contain wireless
carbon monoxide alarms,
smoke and carbon monoxide
•06 •
The wireless interlinked alarms in one multi-pack have already been
interconnected to each Other, so the alarms in each mufti-pack have
their own independent interlinked network. If you have more than
one multi-pack, you will need to connect them all to the same
network, but you do not have to disconnect each alarm
individually. Choose one multi-pack as your base network and
connect the other multi-packs to it.
NOTE!Thefollowing instructions regarding wirelessinterconnection are applicable
to AEGISLINK wirelessinterlinked alarms only.
How to Interconnect
1. Make sure you only work with 2 units at a time, and that they are both
activated to ensure successful connection.
NOTE:TOactivate your alarm, remove the back cover from the device andpull out
the battery insulating film from the battery compartment. ro learn how to turn on
different models OfWirelessinterlinked alarms, please refer to their specific user
manuals for more details.
2. Press the pinhole pairing button on the back of one of the 2 units
using the included pin. It will beep once and the LEDwill flash red
slowly, indicating it hasentered pairing made and is waiting for a new
unit to be added, Hold down the pinhole pairing button on the other
unit until it beeps once and its LEDflashes red rapid y asit is searching
for a unit to connect to.