Technical Specifications - Aegislink S-Rf200 Benutzerhandbuch

2. If the Initiating Unit Is Triggered by CO:
When one CO alarm is triggered in the interconnected network, the
unit will beep 4 times every 5.8 seconds, paired with the LED flashing
red, Any other interlinked units in the network will follow suit—they
will beep 4 times every 5.8 seconds, paired with the LEDthat flashes
red 4 times first, followed by the LED that tlashes green once with
every beep. When the CO concentration level drops below the alarm
threshold, the alarm will cease.
• Whenone unit istriggered, other interconnected units Will sound. Ifthe smoke
alarm and COalarm are triggered in the network at the same time, the alarm signal
Ofthe smoke alarm Will take priority over that of the COalarm.
• This alarm has arelay function that extends the wireless interconnected network for
wide detection coverage.
Silence Mode
f you pressthe silence button during an alarm state,the unit will be in
the silence mode for 9 minutes. During the silence mode, the LEDwil
flash red once every 5 seconds,The alarm will enter the normal mode
after 9 minutes.
• You can silence all interconnected units by pressing the test/silence button on one Of
the units. If one unit isstill alarming, it is the initiating unit (the unit that detected
danger); to silenceall interlinked units, you must alsopressthe test/silencebutton
on the initiating unit.
• 22 •
• While interconnected, the initiating unit cannot be triggered again during the
9-minute silence duration. However,all other interconnected units can be triggered
again if they detect danger during the silencemode.
Technical Specifications
Power Supply Replaceable 3 V CRI23A lithium battery
Operating Life
10 years
Battery Life 5 years
Sensor Type Photoelectric
Safety Standard EN 146042005+AC:2008
Operating Ambient 40 1000F(4.4 37.80C)
Temperature
Operating Relative s 85% (non-condensing)
Humidity
Alarm Loudness > 85 dB at
pulsing alarm
Silence Duration About
Operating Frequency 868 MHz
32±03 kHz
9 minutes
• 23 •