Genius INVICTUS WD5 Gebrauchsanleitung Seite 24

GB
Empty both tanks immediately after use to avoid accidental leakage.
„
Clean all parts from dirt directly after use
„
Allow all parts to dry completely before stowing to avoid the formation of bacteria or unpleasant odours.
„
Do not use harsh or abrasive cleaning agents or cleaning pads. They could damage the surface. Clean the housing
„
and accessories with a damp cloth if necessary.
Replace the sponge filter every 6 months.
„
Cleaning the fresh water tank
1. Press the clean water tank down slightly and remove it from the main appliance.
2. Unscrew the lid and remove any water that may still be inside.
3. Allow the tank to dry completely.
Clean the waste water tank and filter unit
1. Remove the waste water tank by pressing the release button down with your thumb and pulling out the waste
water tank at the same time (see Fig. I).
2. Remove the filter unit by pulling it upwards out of the tank (see Fig. J).
3. Remove the waste water from the tank.
4. If there is stubborn dirt on the inside wall of the tank, clean the tank with the cleaning brush or a cloth (see Fig. K).
5. Remove the filters and open the mesh filter on the underside. Remove the sponge filter (see Fig. L).
6. Clean the waste water tank, filter unit, mesh filter and sponge filter thoroughly with clean water.
7. After cleaning, allow all parts to dry completely, put the filter back in the filter unit and reattach the waste water
tank to the main unit.
Clean cleaning foot (see Fig. M)
1. Open the release and remove the brush roller cover.
2. Grasp the brush roll on the left and remove it upwards.
3. Remove any hairs, threads or similar from the roll.
4. Remove dirt from the intake duct with a damp cloth. Do not hold the cleaning foot under running water to avoid
damaging the electrical connections.
5. Clean the brush roll and the cover under running water.
6. Allow all parts to dry fully.
7. Put back the brush roll.
8. Put on the brush roll cover and snap it into place.
24
Instruction manual