LED indicator
Field / Display
On/off button
Press x 1
Press x 2
Press x 3
Spray button (can
Press x 1
only be activated
in conjunction with
Press x 2
standard mode)
Self-cleaning
Press x 1
button
Self cleaning
1. After use, place the appliance on the storage and cleaning unit.
2. To start the self-cleaning function, press and hold the self-cleaning button for about 3 seconds.
3. The self-cleaning process takes about 2 minutes. To do this, there must be water in the clean water tank and
sufficient battery power must still be available.
4. After self-cleaning, the appliance switches off automatically.
5. After self-cleaning, please clean the wastewater tank and dry the pick-up and cleaning station.
6. To stop the self-cleaning function prematurely, press the self-cleaning button or the ON/OFF button.
Use of the accessories
1. Cleaning brush: With bristles to remove stubborn dirt from the waste water tank and the suction opening. At the
other end of the brush is a fold-out blade to cut away tangled hair (see Fig. G).
2. Storage and cleaning unit: For storing the appliance and cleaning the brush rolls with the self-cleaning
function. The filter and brush roll can be stored in the side recesses for drying (see Fig. H).
Storage
Store the appliance in a dry place and protect it from excessive heat or direct sunlight.
Cleaning and user maintenance
WARNING!
Risk of electric shock
Switch the appliance off and disconnect it from the mains before cleaning or
user maintenance.
Never hold the appliance or accessories under running water or immerse them in
water or other liquids.
Instruction manual
Function
LED indicator
Device is switched
green LEDs flash
on
white LED flashes
Boost mode
blue LEDs flash
Appliance is
Off
switched off
Water quantity is
Green LEDs flash
increased
Blue LED flashes
Water discharge is
Green LEDs flash
switched off
Self-cleaning is
Blue LEDs blink
activated
White LED blinks
Suction
Water discharge
power
Normal
low
High
Off
Off
Off
Normal
High
Normal
Off
Normal
low
GB
23