Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.
TROUBLESHOOTING
PROBLEM
Motor is slow or weak
Motor overheats
When milling, the cut burns
the workpiece or stalls the
motor
Tilt/bevel & Height handles
are hard to turn
The spindle does not tilt or
does not move lower/high-
er
Spindle moulder vibrates
excessively
Spindle moulder does not
start.
Power switch does not
function
CAUSE
Voltage from power source
is low or unstable.
Circuit is overload with
appliances, lights or other
electrically powered equip-
ment
Motor does not receive
power on .all phases (for
400V model)
Motor windings are dama-
ged
Motor is overloaded
Dull milling tool
Dull milling tool
Warped workpiece
Dust has accumulated on
the mechanisms inside the
base
Bevel lock handle is not
fully released
Height lock handle is not
fully released
Floor surface is not hard, or
is uneven.
V-belt is damaged
milling tool is damaged
Loose bolts, screws, nuts
Motor cord is not plugged
in
Circuit fuse is blown
Circuit breaker is tripped
Motor cord or switch is da-
maged
Power switch contacts are
burned
capacitator is defect
Wiring connections are loo-
se or damaged
SOLUTION
Request a voltage check
from the local power com-
pany.
Do not use other applian-
ces or electrically powered
equipment on the same
circuit when usin the Table
Saw.
Let this be checked by an
electrician!
have the motor be checked
by an electrician and repai-
red/replaced if necessary
Decrease the load by redu-
cing the feeding speed
Sharpen/replace the milling
tool
replace/sharpen milling
tool.
Plan/replace workpiece
Clean and lubricate the me-
chanisms inside the base.
Fully release
Fully release
Check and change
Replace the belt
replace the milling tool
check and tighten
Plug in
Replace
Replace circuit breaker
Reset circuit breaker, have
the motor cord or switch
replaced
Have the switch replaced
Request a voltage check
from the local power com-
pany
Have the wiring connec-
tions checked/ repaired
Werbung
