Fluid Tunturi RW30 Bedienungsanleitung Seite 11

Assembly Instructions
..........................................................................................................................................................
STEP 6
REQUIRED
Rower Seat [3]
Rower Seat Frame [4]
4x M6 Washer [13]
4x M6x20mm Bolts [17]
STEP 7
REQUIRED
Rower Seat [3]
Rower Seat Frame [4]
WARNING
Do not put fingers in
between Side Rail and
wheel carriage.
STEP 8
REQUIRED
Side Rail [2]
Rear End Cap [with Rubber
Pads [9]
4x M6 Washer [13]
4x M6x10mm Bolts [16]
Installing Rower Seat
Install the Rower Seat[3] onto the Rower Seat Frame[4] using 4x
M6x20mm Bolts[17] and 4x M6 Washers[13].
Installing Rower Seat into the Side Rails
Slide the Assembled Rower Seat into the Side Rails as shown. The Seat
Indentation must be towards the rear of the Rower.
NOTE: Clean Wheels and tracks weekly with a soft dry cloth in order to
decrease the rate of wear on both Wheels and track.
Installing the Rear End Cap (with Rubber Pads)
Install the Rear End Cap[9] to the Side Rails[2] using 4x M6 x10 Bolts[16]
and 4x M6 Washers[13].
Rower Seat
Rower Seat Frame
M6 Washer
M6x20mm Bolt
M6x10mm Bolt
M6 Washer
9
Indentation