Setting The Temperature - Philips GC 8280 Bedienungsanleitung

On On
MAX MAX
The water tank refill light flashes and steam ironing is no longer possible.
1 Remove the water tank and fill it.
 Put the water tank back into the steam generator.
The iron is ready for steam ironing again.
,

setting the temperature

1 Put the mains plug in an earthed wall socket and press the on/off
button once.
Note: When you switch on the appliance, it automatically heats up to the last
used temperature setting.
The power-on light of the on/off button goes on.
,
The display lights up and you hear a short beep. The following
,
message moves across the display:
'WELCOME TO PHILIPS - CHECKING SENSORS - CHECKING WATER
- WARMING UP'.
The steam light on the steam generator flashes.
,
After approx. 2 minutes, the steam light stays on continuously to indicate
that the steam generator is ready for steam ironing.
 Check the laundry care label of the article to be ironed to determine
the required ironing temperature.
 Use the + and - temperature buttons to set the required ironing
temperature or fabric type.
The display shows the fabric type for which the selected
,
temperature setting is most suitable (see chapter 'Iron display guide').
The display indicates that the iron heats up or cools down to the
,
selected temperature.
A double beep and a message on the display indicate that the soleplate has
reached the selected temperature.
tips
- If you do not know what kind or kinds of fabric an article is made of,
determine the right ironing temperature by ironing a part that is not
visible when you wear or use the article.
- If the fabric consists of various kinds of fibres, always select the
temperature required by the most delicate fibre, i.e. the lowest
temperature. For example: if a fabric consists of 60% polyester and 40%
cotton, it must be ironed at the temperature indicated for polyester (
1) and without steam.
- Start ironing the articles that require the lowest ironing temperature,
i.e. those made of synthetic materials.
EnGlish
9