Features; Installation - GM-Racing Purple SX7 Gebrauchsanleitung

Features:

5
Adjustable torque control
5
Turbo function
5
Minimum brake
5
Maximum brake
5
Automatic brake
5
Adjustable operating frequency
5
Adjustable start current
5
IDA-System
5
Re-generative braking system
5
BEC voltage supervision
5
LED function control light

Installation

Securely mount the speedo to the chassis of
your car using double sided (servo) tape.
Position the unit as low as possible in the car to
maintain a low centre of gravity, and keep all
power wires at least 3cm (1.5") from the radio
receiver.
Puple SX9
Part# 2853
Connect the black wire to the negative (-ve)
terminal of your battery pack.
Connect the blue wire to the negative (-ve)
terminal of your motor.
Connect the red wire to the positive terminal of
your battery pack and the (+ve) terminal of your
motor.
Connection
Battery -
Solder theSMD-Schottky-Diode
to the motor or motor wires
Or
Motor -
Cut the middle pin
91535
Motor -
Motor +
Or
91505
Reciever wire
Battery +
Motor +
Battery+
Please use only high end gold connectors.
Connecting the Schottky-Diode:
Connect the Schottky-Diode on the motor or the motor
wires. (See picture!)
Connect the power capacitor
battery+ and battery-
Try to keep the power wires in your car as short as
possible to increase efficiency and reduce voltage loss
to your motor. Make sure that there are no 'solder
bridges' between the three soldering posts on your
speedo, as this will destroy the unit and void your
warranty.
Plus
Connect long lead
to power wire pos.
Connect short lead
to power wire neg.
ON/OFF-Switch
with right polarity to
Part# 91539
Minus
Mark for minus
of capacitor
RS232: IDA-System
14