Switching On The Machine; Information About Various Floorings; Trouble Shooting - Wolff Extro-Stripper Betriebsanleitung

5.2 Switching on the machine

The EXTRO-STRIPPER is equipped with a power-on indicator
lamp and red lever located at the top of the switch housing. The
switch has a restart protection for low-voltage failures.
If the lamp does not indicate power-on, use another power
socket or check power supply.
The machine is switched on by pulling the red lever. The drive
and the impact system start at the same time.
When the red lever is released, the machine is switched off.
Note the after-running of the machine.
6.0 Information about certain floor coverings
Needlepunch felt and tufted carpets on jute hessian backings
Cut into strips of approx. 35 cm (14 inch) width. If the flooring is
bonded very tight, cut strips smaller. The machine should remove
the flooring without slipping wheels.
Carpets with foam backing
A sharp blade is essential in order to ensure the floor covering is
removed together with the foam backing.
Remove floorings across the width, particularly if you have an
uneven sub-floor.
Tiles
Use blade of the same width as the tiles and use a new blade.
Tiles above size 30 x 30cm (12 x 12inch) have to be cut into half.
If the sub-floor is uneven, use smaller blades.
In all cases, check from time to time to ensure the blade is still
sharp. If it is not or any distortion has occurred, replace it imme-
diately.

7.0 Trouble Shooting

Trouble Eventual cause
Machine does not Power supply
run disconnected
blown fuse
defective cable or plug
Undue force necessary Blade is blunt
or excessive vibration
Excessive vibration Expendable parts are
worn out
01/2006 EXTRO-STRIPPER 2, 230 V Artikel. Nr 038588, 115 V Item-No.
Elimination
Have machine
repaired by a qualified
electrician, respective
change parts
Change blade
Return machine for
service and/or repair
039121,RÄSM
13