5_First Steps; Battery; 1_Installing And Extracting The Battery; 2_Charging The Battery - RugGear RG100 Schnellstartanleitung

10

5_FIRST STEPS

5.1_BATTERY

The battery is inserted into the back of the mobile phone. The
battery is not fully charged when the mobile phone is purchased,
but it contains enough energy to power on the phone.
To obtain best battery performance and battery life, let the battery
discharge completely before charging it completely for the first
three charging cycles.

5.1.1_INSTALLING AND EXTRACTING THE BATTERY

When installing the battery, insert the teeth at the top of the battery
into the corresponding notches of the mobile phone, then press
the battery down and secure it by turning the two screws with the
delivered screw driver. Ensure that the battery is safely in place
before powering on the phone.
QUICK START QUICK START

5.1.2_CHARGING THE BATTERY

5.1.3_BATTERY USE

In actual use, the standby time and talk time of the phone varies
with the network status, working environment and usage.
When the power of the battery is lower than normal, the phone
will prompt you to charge it. Please charge the battery; otherwise
you may lose any files which have not been saved.
If you do not charge for a long time, the phone will be powered off
automatically.
WARNING
The phone may only be charged at ambient temperatures in
a range from 5 °C – 35 °C. Please do not use charging equipment
if the temperature exceeds this range. Only use the approved
USB-cable and charger. Using any other cable may cause danger
and will void the warranty.

5.1.4_POWER BANK USE

The RG100 can be used as a power bank to charge other
mobile phones.
Connect the USB cable with the USB-A plug above the volume side
keys. Connect the micro USB connector to the phone you want
to charge. Activate the USB charging function in Menu/Charge Pal.
Connect the USB-cable with the phone as
indicated in the picture.
Connect the plug with the socket of the
power supply.
After charging, remove the USB-cable from
the charger.
11
EN