Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.6 Safety Instruction
Watch your hands.
Take care of your belongings.
O
Keep treadmill upright and put it in a space
with supporting
points on both sides. Please
keep away from children.
19
Do not fold before power off.
Do not get on and off
when
the treadmill
operating.
1.7 Maintenance
and Adjustments
1
Clean
the treadmill
• Disconnect
• Add a small quantity of mild cleaner to a 100% cotton cloth. Do not spray the cleaner directly
on the walking belt or use acidic and corrosive cleaner.
• Do not wipe under the walking belt.
• After a period of exercise, dust and stains may appear on the rear floor. This is normal and
can be simply wiped.
2
Walking Belt Slipping and Correction
• Simultaneously
control
for
over
• Front panel will show "CALI" and keep running with speed 3km/h (2mi/h).
• Walking belt goes to the left: Turn the left adjusting
• Walking belt goes to the right: Turn the right adjusting hole screw clockwise by 1/4 turn.
• Walking belt is slipping: Turn the left and right adjusting screws clockwise for 1/2 turn at the
same
time.
• After each adjustment, the treadmill needs to run for 1-2 minutes to verify the adjustments
Please adjust again if necessary.
• Press the function key to stop treadmill.
CAUTION:
BELT
TENSION.
3
Walking belt lubrication
• Power off the treadmill and unplug the power cord
• Lift the edge of the walking belt and smear the inner surface with silicone oil.
• Start the treadmill to run at a speed of 3 km/h (2 mi/h) for 10-20 seconds.
• 5-10 ml of silicone oil is required for each lubrication. Excessive
slipping and affect normal use
• Lubricate the walking belt every three months
all sources of power before cleaning the treadmill.
press and hold both Mode Button and Speed Increase Button on the remote
3 seconds
until
device
start.
hole screw clockwise by 1/4 turn.
DO
NOT
OVERTIGHTEN
THE
BELT.
PLEASE
MAINTAIN
ORIGINAL
EXCESSIVE
BELT
TENSION
WILL
CAUSE
DAMAGE
TO
silicone oil may cause
FACTORY
MOTOR.
20
Werbung
