Compliance Statements - Sentry Collision Multi-Zone Montage- Und Gebrauchsanleitung

Compliance Statements

FCC
This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when the equipment is
operated in a commercial environment. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area is
likely to cause harmful interference in which case
the user will be required to correct the interference
at his own expense.
However, there is no guarantee that interference
will not occur in an installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined by
turning the equipment o and on, the user is
encouraged to try to correct the interference by one
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
di erent from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.
FCC Caution: Any changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to
operate this equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
This device may not cause harmful interference;
and
This device must accept any interference received,
including interference that may cause undesired
operation.
IC
This device complies with Industry Canada's
license-exempt RSSs. Operation is subject to the
following two conditions:
This device may not cause interference; and
This device must accept any interference, including
interference that may cause undesired operation of
the device.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes:
l'appareil ne doit pas produire de brouillage;
l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le
fonctionnement.
The product complies with the Canada portable RF
exposure limit set forth for an uncontrolled
environment and are safe for intended operation as
described in this manual. The minimum separation
distance for portable use is limited to 15mm
assuming use of antenna with 2 dBi of gain. The
further RF exposure reduction can be achieved if
the product can be kept as far as possible from the
user body or set the device to lower output power if
such function is available.
Le produit est conforme aux limites d'exposition
pour les appareils portables RF pour les Etats-Unis
et le Canada établies pour un environnement non
contrôlé. La distance de séparation minimale pour
l'utilisation portative est limitée à 15mm en
supposant l'utilisation de l'antenne avec 2 dBi de
gain. Le produit est sûr pour un fonctionnement tel
que décrit dans ce manuel. La réduction aux
expositions RF peut être augmentée si l'appareil
peut être conservé aussi loin que possible du corps
de l'utilisateur ou que le dispositif est réglé sur la
puissance de sortie la plus faible si une telle
fonction est disponible.
EU
This device complies with the essential
requirements of the 2014/53/EU – Radio Equipment
Directive (RED). The following test methods have
been applied in order to prove presumption of
conformity with the essential requirements of the
2014/53/EU – Radio Equipment Directive (RED):
EN 62368-1:2014/A11:2017
Safety requirements for audio/video, information,
and technology equipment
EN 300 328 v2.2.2 (2019-07)
Electromagnetic compatibility and Radio Spectrum
Matters (ERM); Wideband Transmission systems;
Data transmission equipment operating in the 2,4
GHz ISM band and using spread spectrum
modulation techniques; Harmonized EN covering
essential requirements under article 3.2 of the
R&TTE Directive
EN 62311:2008 | EN 50665:2017 | EN 50385:2017
RF exposure
EN 301 489-1 v2.2.0 (2017-03)
Electromagnetic compatibility and Radio Spectrum
Matters (ERM); ElectroMagnetic Compatibility
(EMC) standard for radio equipment and services;
Part 1: Common technical requirements
EN 301 489-17 V3.2.0 (2017-03)
Electromagnetic compatibility and Radio spectrum
Matters (ERM); ElectroMagnetic Compatibility
(EMC) standard for radio equipment and services;
Part 17: Specific conditions for 2,4 GHz wideband
transmission systems and 5 GHz high performance
RLAN equipment
EU 2015/863 (RoHS 3)
Declaration of Compliance – EU Directive 2015/863;
Reduction of Hazardous Substances (RoHS)
This device is a 2.4 GHz wideband transmission
system (transceiver), intended for use in all EU
member states and EFTA countries, except in
France and Italy where restrictive use applies.
In Italy the end-user should apply for a license at
the national spectrum authorities in order to obtain
authorization to use the device for setting up
outdoor radio links and/or for supplying public
access to telecommunications and/or network
services.
This device may not be used for setting up outdoor
radio links in France and in some areas the RF
output power may be limited to 10 mW EIRP in the
frequency range of 2454 – 2483.5 MHz. For detailed
information the end-user should contact the
national spectrum authority in France.
[Bulgarian]
Protection Products ,
CLN-MZN
2014/53/EC
Hrvatski [Croatian] Sentry Protection Products ovim
putem izjavljuje da je ovaj uređaj CLN-MZN
sukladan osnovnim zahtjevima I ostalim bitnim
odredbama Direktiva 2014/53/EU
Česky [Czech] Sentry Protection Products tímto
prohlašuje, že tento CLN-MZN je ve shodě se
základními požadavky a dalšími příslušnými
ustanoveními směrnice 2014/53/EU.
Dansk [Danish] Undertegnede Sentry Protection
Products erklærer herved, at følgende udstyr
CLN-MZN overholder de væsentlige krav og øvrige
relevante krav i direktiv 2014/53/EU.
Deutsch [German] Hiermit erklärt Sentry Protection
Products, dass sich das Gerät CLN-MZN in
Übereinstimmung mit den grundlegenden
Anforderungen und den übrigen einschlägigen
Bestimmungen der Richtlinie 2014/53/EU befindet.
Eesti [Estonian] Käesolevaga kinnitab Sentry
Protection Products seadme CLN-MZN vastavust
direktiivi 2014/53/EL põhinõuetele ja nimetatud
direktiivist tulenevatele teistele asjakohastele
sätetele.
English Hereby, Sentry Protection Products,
declares that this CLN-MZN is in compliance with
the essential requirements and other relevant
provisions of Directive 2014/53/EU.
Español [Spanish] Por medio de la presente Sentry
Protection Products declara que el CLN-MZN
cumple con los requisites esenciales y cualesquiera
otras disposiciones aplicables o exigibles de la
Directiva 2014/53/UE.
Ελληνική [Greek] ΜΕ ΤΗΝ ΠΑΡΟΥΣΑ Sentry
Protection Products ΗΛ ΝΕΙ ΟΤΙ CLN-MZN
ΣΥΜΜΟΡΦ ΝΕΤΑΙ ΠΡΟΣ ΤΙΣ ΟΥΣΙ
ΑΠΑΙΤΗΣΕΙΣ ΚΑΙ ΤΙΣ ΛΟΙΠΕΣ ΣΧΕΤΙΚΕΣ ΙΑΤΑΞΕΙΣ
ΤΗΣ Ο ΗΓΙΑΣ 2014/53/EE.
Français [French] Par la présente Sentry Protection
Products déclare que l'appareil CLN-MZN est
conforme aux exigences essentielles et aux autres
dispositions pertinentes de la directive 2014/53/UE.
Íslenska [Icelandic] Hér, Sentry Protection Products,
því yfir að þetta CLN-MZN tæki er í samræmi við
grunnkröfur og önnur viðeigandi ákvæði tilskipana
2014/53/ ESB
Italiano [Italian] Con la presente Sentry Protection
Products dichiara che questo CLN-MZN è conforme
ai requisiti essenziali ed alle altre disposizioni
pertinenti stabilite dalla direttiva 2014/53/UE.
Latviešu valoda [Latvian] Aršo Sentry Protection
Products deklarē, ka CLN-MZN atbilstDirektīvas
2014/53/ES būtiskajāmprasībām un citiemar to
saistītajiemnoteikumiem.
Lietuvių kalba [Lithuanian] Šiuo Sentry Protection
Products deklaruoja, kad šis CLN-MZN atitinka
esminius reikalavimus ir kitas 2014/53/ES Direktyvos
nuostatas.
1.4 Bluetooth
The CLN-MZN has been grated Bluetooth® Listing by
BT_SIG.
Sentry
ΕΙΣ