eQ-3 HomeMatic IP HmIP-HAP Installations- Und Bedienungsanleitung Seite 18

RestHre factHrly settings
8 RestHre factHrly settings
The factory settings of your Access
Point as well as of your entire installa-
tion can be restored. The operations
distinguish as follows:
• Resetting the Access Point:
Here, only the factory settings of
the Access Point will be restored.
The entire installation will not be
deleted.
• Resetting and deleting the entire
installation:
Here, the entire installation is re-
set. Afterwards, the app has to be
uninstalled and reinstalled. The
factory settings of your single
Homematic IP devices have to be
restored as to enable them to be
connected again.
8.1 Resetting the Access Point
To restore the factory settings of the
Access Point, please proceed as fol-
lows:
• Disconnect the Access Point from
the power supply. Therefore, un-
plug the mains adapter.
• Plug-in the mains adapter again
and press and hold down the sys-
tem button for 4s at the same time,
until the LED will quickly start flas-
hing orange.
• Release the system button again.
• Press and hold down the system
button again for 4 seconds, until
the LED lights up green. If the LED
lights up red, please try again.
• Release the system button to finish
the procedure.
The device will perform a restart and
Access Point is being reset.
8.2 Resetting and deleting the entire
installation
During the reset, the Access Point
must be connected to the cloud
so that all data can be deleted.
Therefore, the network cable
must be plugged in during the
process and the LED must light up
blue continuously afterwards.
To reset the factory settings of the en-
tire installation, the procedure descri-
bed above must be performed twice in
succession, within 5 minutes:
• Reset the Access Point as descri-
bed above.
• Wait at least 10 seconds until the
LED permanently lights up blue.
• Immediately afterwards, perform
the reset for the second time by
disconnecting the Access Point
from the power supply again and
repeating the previously described
steps.
After the second restart, your system
will be reset.
18