hillvert HT-GP-007 Bedienungsanleitung Seite 11

Use a strong rope to attach to the pump handle. Dip the pump into the liquid at an
o
angle to prevent bubbles from forming under the device, which can interfere with
suction.
Placement:
•
Lower the equipment slowly into the liquid container and adjust the position as
o
necessary once submerged. Arrange the pump at the bottom of the container.
Securing the Rope:
•
After lowering, secure the rope's end to allow the pump to be handled safely while
o
hanging.
Power Connection:
•
Once the pump is in position, connect it to the main power source to initiate
o
operation.
Device use and functionality
Functions
1. Automatic Standby Mode:
When the outlet valve is closed, the pump enters a standby mode, maintaining
o
pressure in the pipeline. The pump remains stopped but is ready to activate
automatically once the outlet valve is opened and pressure is released.
2. Dry Operation Protection:
If the pump is unable to pump water due to insufficient water levels, it enters dry
o
operation protection mode, stopping operation. The pump will only restart when the
power is reconnected.
3. Leakage Detection and Protection:
In case of a minor leak in the pipeline that causes the pump to start frequently, the
o
pump enters a protection mode and stops. It will only restart after the power is
reconnected.
Operation Checklist
Before turning on the pump, ensure the following conditions are met:
1. The pipeline includes a metal tube or pressure hose capable of withstanding pressure.
2. All pipe joints are reliably sealed.
3. The pump is securely fixed in its position.
4. The diving depth does not exceed the technical parameter limits.
5. All electrical connections comply with safety instructions.
6. The outlet valve is open.
EN