PCE Instruments PCE-DLT 10 Bedienungsanleitung Seite 19

3. Use a fastening rail and two holding clips to fasten the sample. Use the screws on the
gripping jaws to fasten the sample properly and to prevent it from getting out of place.
Wait for the temperature display to reach the test temperature (50 ... 55 °C). The
4.
temperature display now turns green.
5. Take off the cover of the water tank. Use gloves due to the high temperatures. Attach
the fastening rail to the holding device (see picture below).
ATTENTION:
During operation, do not touch the tank. This can cause
burns.
The distance between the bottom edge of the sample
and the water surface should be approx. 500 mm. Use
© PCE Instruments
16