Radio Cloning; Radio Id Editing - Albrecht Tectalk Duro XS Bedienungsanleitung

10. Radio Cloning

1. Connect two radios (the master and the slave) using a cloning
cable.
2. Turn on the master radio pressing PTT button and Mode(M)
button simultaneously.
The radio LED blinks green.
3. Turn on the slave radio or radios pressing PTT button and
Mode(M) button simultaneously.
The radio(radios) LED blinks green too.
4. Press and hold the master radio until the master radio LED
lights green as well as the slave radio(s) lights green. During
cloning, the slave radio(s) blinks among green, orange and red.
5. Turn off your radios and disconnect the cloning cable from
the radios.

11. Radio ID Editing

An up to 3 digit Radio ID can be programmed when the radio is
switched on. You can customise this Radio ID to identify your
radio.
To enter the Radio ID edit mode, switch on the radio whilst pres-
sing the Menu button.
1. The first digit is blinking.
2. Use the UP or DOWN button to change the character.
3. Press the Menu button to select the next digit.
4. Repeat the step 2 and the step 3.
5. Turn off the radio to finish editing.
English 41