Herunterladen Inhalt Inhalt Diese Seite drucken

Intended Treatment Areas; Tip: White Eye Pencil; How To Achieve Optimal Results - Philips TT3003 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für TT3003:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 29
Note: Fully charged batteries offer at least 370 flashes at intensity 5. How
long you can use the appliance depends on the size of the area to be
treated and the intensity setting used.

Intended treatment areas

The appliance is intended to treat unwanted hairs on the underarms,
shoulders, back, chest, arms, pubic area (excluding the scrotum) and legs.
Using the appliance on the shoulders, chest, back and legs
If you use the appliance to treat your shoulders, chest, back and legs you
may have to recharge the appliance during the treatment. This is normal.
How long you can use the appliance depends on the size of the treatment
area and the intensity setting used.
Tip: If you want to treat your back and your shoulders, you require the help
of your partner or a friend to guarantee complete coverage and best results.
Tip: The back and chest are often tanned. Take special care to select the
appropriate intensity for treating the tanned skin to prevent skin reactions.

Tip: White eye pencil

To help you remember what part of your skin you have already treated, you
can mark sections on your leg with a white eye pencil.
1 Take a white eye pencil and draw a line on your leg. Start at any point of
your leg and draw a straight line.
3 cm
2 Draw additional lines at a distance of 3cm from the first line if you use the
appliance horizontally or at a distance of 1cm if you use the appliance
vertically.
Perform the treatment section by section. If you need to take a break during
a session, just mark the last treated area with the same eye pencil and
resume the treatment later.
Note: Only use a white eye pencil. Dark colours absorb the light and may
cause skin irritation.

How to achieve optimal results

- It is normal that hairs are still visible after the first few treatments (see
chapter 'Introduction', section 'Working principle' for more information).
- To remove all hairs successfully and prevent the hair follicle from
becoming active again, the treatments have to be repeated once every
two weeks for the first two to three months. Your skin should be smooth
by then. Please read section 'Maintenance phase' to find out how you
can keep these results.
19
English

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis