Using The Appliance - Philips QC5390/32 Bedienungsanleitung

using the appliance

Clipping with comb
The appliance comes with 2 combs for different hair lengths.
The hair length settings are indicated in millimetres on the comb.
The settings correspond to the remaining hair length after clipping.
1 Select the comb you want to use.
The small comb cuts the hair to a length of 3mm to 22mm.
The large comb cuts the hair to a length of 23mm to 42mm.
2 Slide the comb straight into the guiding grooves on both sides of
the handle ('click').
3 To set the comb to the desired setting, turn te zoom wheel to
the desired hair length setting.
The display on front of the appliance shows the selected hair length
,
in millimetres after cutting.
After 8 minutes, the display goes out to save energy. To activate
,
the display again, turn the zoom wheel or press the on/off button.
Tip: Write down the hair length settings you selected to create a certain
hairstyle as a reminder for future clipping sessions.
4 Press the on/off button to switch on the appliance.
5 Move the appliance through the hair slowly.
tips
- To clip most effectively, move the appliance against the hair
growth direction.
- Since all hair does not grow in the same direction, you need to move
the appliance in different directions (upwards, downwards and across).
- Make sure that the flat part of the comb is always fully in contact
with the scalp to obtain an even result.
- Make overlapping passes over the head to ensure that you cut all
the hair that needs to be cut.
6 Regularly remove cut hair from the comb.
If a lot of hair has accumulated in the comb, remove the comb from
the appliance and blow and/or shake the hair out of it.
English
7