Starting The Programme; Programme Time/Programme Status; Changing The Programme Before Starting; Cancelling The Programme - Schulthess Spirit eMotion 7030i Bedienungsanleitung

Starting the programme

Lightly press the Start button.
The pilot lamp illuminates and the programme runs
through automatically.
With child lock activated:
Hold down the Quick wash button and actuate the Start
button.
Programme time / programme status
The individual programme steps and remaining time are
displayed during the washing programme.

Changing the programme before starting

Lightly press the desired programme button once again.
Select additional programmes.
Select any additional functions that may be needed.

Cancelling the programme

Cancel the programme by repeatedly pressing the «Quick
wash» button until «Open door» is displayed.
With child lock activated:
Hold down the start button while selecting a new
programme.
When restarting the programme:
Repeat the detergent addition.
Ending the programme with rinsing stop
You have selected the additional rinsing stop function.
The laundry will be held in the last rinse water.
The display will show «Rinsing stop».
You have 2 options for ending the programme:
The laundry can be spun
If the spin speed was not changed when the
programme was selected, this can be done using the
selection button for the spin speed
Press the start button.
The water will be pumped out and the laundry spun.
The laundry can be removed dripping wet
Press the Quick Wash button twice.
The rinse water is pumped out.
By pressing the
early to be kind to your laundry (e.g. curtains).
With child lock activated:
Hold the start button down at the same time.
.
button, the spin can be ended
38

Programme end

The programme end is shown by the time 00:00h and
the words «Open door».
Tumbling the washing
The tumbling phase at the end of the programme lasts
5 minutes (excluding especially gentle wash programmes
such as wool, e.g.) and prevents creasing the laundry.

Removing the laundry

During the loosening up phase:
(Drum is still turning / Time indicator 00:00h)
Press the Quick Wash button once.
(Halt programme)
Press the door open button and
remove the laundry.
At the end of the loosening-up phase:
Press the door opening button and
remove the laundry.
Remove any foreign objects (e.g. paperclips) from the
drum and rubber seal!
Otherwise there is a risk of rust!
Leave the loading door ajar to allow the machine dry out.

Switching off the machine

Close the water taps
In machines with Aquastop this is not required, as this
safety equipment will automatically stop the water inflow
behind the tap at the end of the programme.
Switch off the main switch (on the building side)
In case of fitted models, the power supply must not be
interrupted to ensure the function of overflow protection.
Aqua-Stop