PeakTech 4065 Bedienungsanleitung Seite 58

5.19.4. Frequency sweeping function
Start frequency: 100H
End frequency: 1 kHz
Sweep time: 3s
Sweep mode: linearity
Trigger source: Internal
5.19.5. Burst
Repeated period: 10 ms
Pulse count: 3
Start phase: 0°
Trigger source: Internal
5.20. Firmware version
Under CHB tone, press 【 Menu 】 key, the firmware version of the generator will be displaye d:
xxxx.xx, which is helpful when repair and could not be set or change.
6. Specifications
6.1 Output characteristics of CHA and CHB
6.1.1. Waveform characteristics
Standard waveforms: Sine, Square, Ramp, Pulse, Noise, Exponent, Logarithm , SINC, half-round,
Cardiogram, Quake.
Arbitrary: 5 waveforms
6.1.2. Sinewave spectral purity
Harmonic distortion: (1Vpp) ≤-40 dBc (≤5 MHz)
Total distortion:
6.1.3. Square, pulse and Ramp characteristics
Edge time of square and pulse: ≤35ns
Overshoot:
Duty cycle of square:
Pulse width:
Ramp symmetry:
6.1.4. Arbitrary characteristics
Waveform length:
Sampling rate:
Amplitude resolution: 10 bits
Bandwidth of filter:
Non-volatile memory: 5 waveforms
6.1.5. Frequency characteristics
Frequency range:
Frequency resolution: 1 μHz, 6 digits
Frequency accuracy:
≤-35 dBc（>5MHz)
(20 Hz ~ 20 kHz, 20 Vpp) ≤0.5%
≤ 10%
0.1% ~ 99.9% (Limited by edge time)
100 ns ~ 2000 s
0.0% ~ 100.0 %
4096 points
100 MSa/s
50 MHz
Sine: 1 μHz ~ 20 MHz
Square, pulse: 1 μHz ~ 5 MHz
1 μHz ~ 1 MHz
Others:
±20 ppm
-57-