Basic Operation - Peaktech 4065 Bedienungsanleitung

【Menu】key:
【Shift/Local】key:
【Output】key:
【Sine】【Square】【Ramp】
【Pulse】keys:
【Waveform】key:
【CHA/CHB】key:
【Trig】key:
【Cal】key:
Unit key:
Options list of menu
Menu
CHA continuous
CHB continuous
FM
AM
PM
PWM
FSK
Frequency sweeping
Burst
Waveform edition
Frequency measurement
Calibration

3.6. Basic operation

Below are some samples to describe the basic operation of the generator, for more complex usage and
problems, please refer to the details in chapter 3.
3.6.1. CHA continuous function
* CHA continuous function: CHA outputs stable and continuous signal with continuous.
Press【Shift】【CHA/CHB】key, select "CHA" option, and set CHA parameters.
* Frequency setting: set frequency value as 3.5kHz
Press【Freq】key and select "Hz" unit, press【3】【.】【5】【kHz】.
* Frequency adjusting: Press【＜】or【＞】key to move the cursor, switch the adjusting knob left or right
to decrease or increase the digit on the cursor position, borrowing from or carrying to the former digit
continuously. Move the cursor left to do rough adjusting, and right to do fine adjusting. The adjusting knob
is applicable for adjusting digits of other options too, which will not be described any more.
* Period setting: set the period as 2.5ms
Press【Period】key and select "s" unit, press【2】【.】【5】【ms】.
* Amplitude setting: set amplitude value as 1.5Vpp
Press【Ampl】key and select "Vpp" unit, press【1】【.】【5】【Vpp】.
* Attenuation setting: set attenuation as 0dB
Press【Menu】key and select "Atten" option, press【0】【dB】.
key for menu, select different options circularly under different
functions(see below function option list).
select shift, or press this key to resume keyboard function under
program control state.
open and close output signal circularly.
shift keys, select respectively sinewave, square, Ramp and pulse four
common waveforms fast.
shift key, select respectively 16 kinds of waveforms with the waveform
sequence numbers.
shift key, select CHA and CHB as output channel circularly.
shift key, manual trigger under frequency sweeping and burst functions
shift key, select parameter calibration function.
The five keys with unit characters above them on the left bottom of the
instrument are not shift keys, but double-function keys, press these
keys directly to execute the functions marked on themselves; when
inputting digits with numeric keys, press these five keys to select the
unit of the inputting and end the digits inputting at the same time.
Option
Amplitude attenuation, output mode, state and waveform storage, state recall
Amplitude attenuation, output mode, AB phase difference, version number
Frequency deviation, modulation frequency, modulation waveform, modulation
source
Modulation amplitude depth, modulation frequency, modulation waveform,
modulation source
Phase deviation, modulation frequency, modulation waveform, modulation
source
Pulse width deviation, modulation frequency, modulation waveform, modulation
source
Hop frequency, hop rate, trigger source
Start frequency, end frequency, sweep time, sweep mode, trigger source
Repeated period, pulse count, start phase, trigger source
Edition point number, horizontal phase, vertical voltage
Gate time
Calibration value: zero, offset, amplitude, frequency, flatness
-37-