Guarantee Restrictions - Philips PT848 Bedienungsanleitung

ENGLISH
18
Problem
The shaver does
not shave as well as
it used to.
The shaver does
not work when I
press the on/off
button.
Water leaks from
the shaver after
cleaning.
The SmartClean
system does not
work when I press
the on/off button.
The shaver is not
entirely clean after
I clean it in the
SmartClean system.

Guarantee restrictions

The shaving heads (cutters and guards) are not covered by the terms of
the international guarantee because they are subject to wear.
Troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, contact the Consumer Care Centre in your country.
Possible cause
The shaving heads are damaged
or worn.
Long hairs obstruct the shaving
heads.
You have not inserted the shaving
heads properly.
The rechargeable battery is
empty.
The temperature of the shaver is
too high. In this case, the shaver
does not work.
During cleaning, water may collect
between the inner body and the
outer shell of the shaver.
The SmartClean system is not
connected to the mains.
You have not placed the
shaver in the SmartClean
system properly, so there is no
electrical connection between
the SmartClean system and the
shaver.
The cleaning cartridge needs
replacement.
Solution
Replace the shaving heads
(see chapter 'Replacement').
Clean the shaving heads one by one
(see chapter 'Cleaning and maintenance').
Make sure that the projections of the shaving
heads fit exactly into the recesses
(see chapter 'Cleaning and maintenance').
Recharge the battery (see chapter
'Charging') or connect the shaver to the
mains.
As soon as the temperature of the shaver
has dropped sufficiently, you can switch on
the shaver again.
During rinsing some water may collect
between the power unit and the housing.
After rinsing this water flows out through
the socket. The power unit is completely
watertight so water cannot reach the
electronic parts of the shaver. Your shaver
continues to be absolutely safe.
Put the small plug in SmartClean system and
put the adapter in the wall socket.
Press down the top cap ('click') to ensure a
proper connection between the shaver and
the SmartClean system.
Replace the cleaning cartridge (see chapter
'Cleaning and maintenance').