Identification Of Parts; Machine Assembly; Petrol And Oil - Texas A/S Compact 290 Bedienungsanleitung

Identification of parts

Figure 3
a. wheel
b. side guards
c. motor
d. activation handle
e. gas control
f. upper handle
g. lower handle right/left
h. earth rod
i. blades

Machine Assembly

Handle
Affix the lower handle as shown in figure 2. The activation handle should be uppermost.
Use the attachment holes on the machine and the handle to adjust position. Fit upper
handle using the bolts supplied.
Blades
Two identical rotating blades are supplied. They should be attached to the gear's axel
using pin bolts, which are locked with a pin.
Figure 5.
Wheel
Place the wheel in the square hole on the motor front as shown in figure 3.
Lock the wheel in the chosen position by pushing in firmly.
Place the wheel ring in the opposite position under operation.
Earth rod
Attach the earth rod as shown in figure 2. There are 2 positions.
Gas Cable
Attach the gas cable using the bolt which follows with the product as shown in figure 4.
Throttle Cable
Check that the throttle cable is fitted correctly. The hook at the end of the cable should be
attached to the eye in the activation handle (figure 4, b).
It may be necessary to remove the holder on the handle.
Side guards
Attach the side guards using the screws supplied.

Petrol and oil

The machine is supplied without oil or petrol. Pour motor oil and
lead free petrol into the engine as appropriate.
For additional information regarding the motor, see the attached
motor guidelines.
11