Stadler Form Finn Gebrauchsanweisung Seite 13

2. Finn mobile is splash-proof (IP44) certified, making him suitable for use
in covered areas outdoors. In such cases, the USB-C connector (22) must
always be protected using the cover provided (see page 7). Make sure
that your device is not exposed to rain or snow. The device should only
be charged by plugging it into a power socket indoors.
3. Switch on the appliance by pressing the on/off button (10). The appli-
ance gives an audible signal. When the device is used for the first time,
the motor will have to align itself first. This can take a couple of seconds.
Note: The device can be controlled using the buttons on the appliance or
via the remote control, which offers more functions.
4. Press the button for the selection of the speed level (15) on the remote
control (14) to change the fan speed (levels 1–8). Pressing the «+» button
once increases the speed by one level. Pressing the «-» button reduces
the speed level. If you would like to increase / reduce the speed by an-
other level, press again. The selected level is shown by the number of
illuminated LEDs (13) (1 LED for level 1, 2 LEDs for level 2, 3 LEDs for level
3, etc.). Note: You can change the speed level on the device itself by
briefly pressing the on/off button (10). Pressing multiple times increases
the level from 1 to 8 and starts again at 1 when you continue tapping.
5. For optimum distribution of cooling air from left to right, activate the
horizontal swing function (12). The appliance now swings at an angle of
120 ° to ensure optimum distribution of cooling air throughout the room.
Press the swing mode button (12) again if the appliance is to remain at
a certain angle.
6. The vertical tilt of the fan can be manually adjusted to an angle of
0–90 °. To change the angle, grasp the fan head with both hands and
carefully tilt it to the desired position.
7. Press the button for the selection of "Natural Breeze" mode (16) for
natural wind conditions. This mode provides an even more pleasant
cooling effect, simulating a natural breeze. The fan speed of this breeze
automatically varies depending on the selected speed level.
8. By pressing the button for the timer (11) you can set the operating time
for between 1 and 8 hours. The selected time is displayed above the
timer button (11) with white LEDs (13). Press once to set the operating
time to 1 h, press the button again for 2 h, and so on. The display (13)
disappears after 4 seconds and shows the speed level. To check the
remaining operating time, briefly press the timer button (11). The LED
display (13) then lights up again. The unit switches off automatically
after the set operating time has elapsed. The illuminated LED next to the
timer button (11) indicates that the timer function is active. If this LED is
not illuminated, the unit is set to continuous operation.
9. Finn mobile: On the top of the foot (9), you will find the status display for
the battery (23):
• Normal operation with fully charged battery: LEDs are not illuminated
• Battery level 10 % or lower: bottom LED flashes
• Battery is charging: LEDs are illuminated constantly
When the device is fully charged, the LEDs will go out. You can now
disconnect the USB cable and use the device in battery mode (up to 35
hours*). To check the battery status, briefly press the button (24). The
status of the battery is shown by the number of illuminated LEDs (1 LED
at 20%, 2 LEDs at 40%, 3 LEDs at 60%, 4 LEDs at 80% and 5 LEDs at
100%).