Stadler Form Finn Gebrauchsanweisung Seite 12

– Keep the device away from heat sources.
– This device contains a lithium battery.
– Do not drop the device. Otherwise the battery may overheat, cause a
fire or malfunction and reduce service life.
– In case of battery leakage: Avoid contact with human eyes and skin.
Collect spillage.
– WARNING: Only use the USB cable provided by the manufacturer. Use
only an external supply with the following specifications: extra low
voltage DC 24 V / 2 A.
Assembly (see page 2 and 3)
Caution: The protection grilles must be properly closed prior to switching
on the appliance so as to avoid any damage or hazards. Ensure that the
securing screw (7) underneath the protection grilles is firmly tightened. Do
not plug the power cable into the socket until you have finished assembling
the device.
• Remove the securing nut for grille (3) and the knob for fixing the fan
blade (5) from motor housing (1) and place the protection grille rear (2)
onto the motor housing (1). Now screw securing nut for grille (3) back
onto the motor housing (1) to fix the protection grille rear (2) in position.
• Attach the fan blade (4) to the motor housing (1) and fix it in position
with the fastening knob (5). Tighten the knob (5) to secure the fan blade
(4).
• Place the protection grille front (6) onto the protection grille rear (2)
and turn the grilles clockwise until they snap into place. The grilles are
installed correctly when the holes for the security screw (7) are at the
bottom and match. Secure the two protection grilles (2 and 6) with the
securing screw (7).
• First insert the connecting pole (8) onto the foot (9) until you hear it snap
into place and finally place the assembled fan head onto the top of the
connecting pole (8).
Note: By leaving out the connecting pole (8), the device can also be used as
a floor or table fan.
Setting up / operation
1. Place Finn / Finn mobile in the desired location on a flat surface. Finn:
Connect the mains cable (20) to a socket with the correct voltage rating.
Finn mobile: Remove the cover for the connector for the USB-C cable (22)
from the manual (page 7). Keep the cover in a safe place as it is essential
for outdoor use: it protects the device against the ingression of water
and dust. Charge the battery completely before using the device for the
first time (approx. 3 hours). To do this, connect the USB-C cable to the
device (22) and plug the power adapter (21) to a socket with the correct
voltage rating. The progress of the charging process is shown by the
illuminated LEDs (1 LED at 20 %, 2 LEDs at 40 %, 3 LEDs at 60 %, 4 LEDs
at 80 % and 5 LEDs at 100 %). When the battery is fully charged, the
battery status display (23) goes out. If the bottom LED starts to flash,
the battery is almost empty (charge level 10 % or less). After the battery
has been fully charged for the first time, you can operate the appliance
without the cable using the power from the integrated rechargeable
battery. A fully charged battery will give the appliance a running time
of up to 35 h*.