Valeo CYCLEE VIEW PLUS Bedienungsanleitung Seite 4

This device complies with the portable exposure requirements of
FCC Part 2.1093.
This device contains licence-exempt
that comply with Innovation, Science and Economic Development
Canada's licence-exempt RSS(s). Operation is subject to the following
two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference
that may cause undesired operation of the device.
This radio transmitter [IC: 31966-VIEWPLUS] has been approved by
Innovation, Science and Economic Development Canada to operate
with the antenna types listed below, with the maximum permissible
gain indicated. Antenna types not included in this list that have a
gain greater than the maximum gain indicated for any type listed are
strictly prohibited for use with this device.
Antenna Types: Printed circuit board antenna with Peak Gain 1.85 dBi
This equipment is exempt from the routine RF exposure evaluation
requirements of RSS-102. This equipment should be installed and
operated with a minimum distance of 5 mm between the antenna and
the user or bystanders. No changes shall be made to the equipment
without the manufacturer's permission as this may void the user's
authority to operate the equipment
6
transmitter(s)/receiver(s)
PRODUCT SPECIFICATIONS
Intended use
The View Plus display is designed to control and give information
about the Valeo Cyclee™ system. New functions, changes in software
may be introduced during the product life.
For some bikes the software specifications may be different than
stated in this manual (default specifications), please refer to your bike
manufacturer if needed.
PRODUCT FEA TURES
The numbering of the components shown refers to the illustrations
associated.
Display:
3. ON/OFF (long press: anti-theft
function)
4. Lights (long press: mileage
navigation)
5. Assistance level selection
6. Display holder
7. USB-C port (for phone
recharge 5V & 2A max. and
diagnostic tool connexion)
Note: the display is equipped with a luminosity sensor. When the
surroundings light drops, the screen backlight will be activated
automatically.
7