x-sense SWS51 Bedienungsanleitung Seite 6

1.Tap "O" and select "Water LeakSensors"in the product list. Then,tap
"Next" to enter the pairing page.
2. FoIow the prompts on the page by pressing the Test/SiIence/Pair
button twice on the bottom
blue rapid y, indicating that the device is waiting to connect to the
Wi-Fi,
3. Tap "Next" to add the device. You will hear "Readyto add the
device."
4. After successfuly connected, you will hear "Device Added" and the
"Device Added" page will appear.Then you can find the water leak
sensor in the device list.
NOTE:Ifyou fail to add the water leak sensor to the network within
60 seconds, the device will automatically exit the network
configuration. Tore-enter the network configuration, you need to
repeat the above steps.
Testing the Device
When the water leak sensoris successfuly added to the base station,
you must test the device to ensure it is operating normally. Pressthe
Test button at the bottom of the device, or you can open your
smartphone app and go to the "Device Settings"of the water leak
sensor.Then tap "Device Test"to test the device. The alarm will deliver
3 beeps paired with the LEDflashing red The sound wil automatical y
of the water leak sensor until it flashes
08
stop after the test is completed. You will receive a push notification on
your smartphone, indicating that the device is functioning properly,
Installing Your Device
Installation Location
You can usethe device near placeswhere water leaksare like y to
occur such as near water pipes, basement sump pumps, dishwashers,
washing machines, toilets, water heaters, window wells, etc.
Installation Method
This sensor can simp y be placed on a flat surface.
Note
1.Do not place the deviceupright, otherwiseno alarm will be triggered.
2.DOnot place the deviceon unevensurfacesasthis maycausefalsealarms.