Cleaning And Maintenance - rawlink 68675 Gebrauchsanweisung

13. Replace it on the start booster.
14. Set the start booster to charge as soon
as possible.
Compressor
Do not use the compressor for more than
ten minutes at a time. Allow the compres-
sor to cool down for about 30 minutes
before using it again.
The start booster is delivered with
compressed air tubes with a fixed tube
nozzle (11) and three extra pump nozzles:
GB
• Use the fixed nozzle for car tyres.
• Use the needle for leather balls.
• Use the plastic nozzle for other types of
ball or other plastic or rubber items.
1. Fit the nozzle to be used, and apply the
nozzle to the object to be inflated.
Attach the nozzle to the fitted nozzle or
the valve of the tyre by pressing down
the arm on the mouthpiece (figure 4).
2. Turn on the compressor by means of the
on/off switch (12) in position I.
3. Keep an eye on the pressure gauge (13)
during pumping!
4. Turn off the compressor by flipping the
on/off switch to position 0 when the
required pressure has been reached.
34
5. Detach any extra nozzle and turn off the
start booster.
Lamp
The lamp (2) can be used as lighting for
work or in emergencies.
• The lamp can be turned on or off by
pressing the on/off switch (9).
Switch the lamp off when not in use.
Storage
The start booster should be stored fully
charged to maintain maximum battery
lifetime.
Remember to charge the battery every
three to five months, regardless of whether
it has been used or not.
Because the battery is sealed, there is no
risk of leakage, and your start booster can
therefore be stored and transported in any
position.

Cleaning and maintenance

During maintenance, the on/off switch (10)
MUST be in the OFF position.
The start booster and battery are
maintenance free. Clean the start booster
with a damp cloth if necessary. Do not use
corrosive or abrasive cleaning agents.