Special Safety Directions - rawlink 68675 Gebrauchsanweisung

Special safety directions

Safety directions for the start booster
• There is high voltage in the battery clips!
Danger to life! Never touch the metal
parts inside the clamps.
• Always keep the start booster out of the
reach of children.
• Batteries release dangerous oxyhydro-
gen gas during charging. Do not smoke,
and keep naked flames away from the
battery.
GB
• If battery fluid spills on skin or in the
eyes, rinse thoroughly with water and
seek medical assistance.
• Only charge your start booster where
there is adequate ventilation.
• Always follow the guidelines for the car
and car battery.
• NEVER allow the red and black clamps
to come into contact with each other,
or the same piece of metal or other
conductive material.
• When connecting to batteries, the red
clamp must always be connected to the
battery's positive terminal (+) first.
• Do NOT connect the black clamp to
the battery negative terminal (-), but to
the chassis or engine block, as far away
from the battery as possible.
• Do not use voltages higher than 12 V for
charging.
• The start booster is only intended for
use with 12 V DC circuits.
• Do not use it as an alternative to a car
battery.
• Never expose your start booster to
direct sunlight, high temperatures or
damp.
• The start booster is delivered with a
partially charged battery, and must be
fully charged before it is used the first
time.
32
• The start booster battery should be
charged every three to five months,
regardless of whether it has been used
or not.
• When disposing of the start booster
battery, you must follow your local
authority rules on electrical appliances
and batteries.
Safety regulations for the compressor
• Do not use the compressor for more
than ten minutes at a time. Allow the
compressor to cool down for about 30
minutes before using it again.
• Keep the ventilation openings clean
and free of dust and dirt. Make sure that
dust and fumes are not drawn into the
compressor.
• Do not blow compressed air directly on
to yourself, other people or animals.
Charging
During charging, the on/off switch (10)
MUST be in the OFF position.
The built-in overload cut-out will ensure
that the start booster cannot overcharge.
When you press the test button (5), the
charge indicator (6) will show the condition
of the battery:
• Red = 0-50% charged
• Green = 50-100% charged
Charging from a power socket
1. Connect the charger (14) to the socket (7).
2. Put the charger in the socket and turn
on the current.
3. The charging indicator (6) flashes several
times, and the battery charges up.
The charging indicator shows the
condition of the battery continually
(red = 0-50 %, green = 50-100 %).
Charging is stopped automatically
when the battery is fully charged.