rawlink 68675 Gebrauchsanweisung Seite 33

Charging from a cigarette lighter socket
Only charge the start booster from the
cigarette lighter socket while the car engine
is running; otherwise the car battery will
run flat.
Do not start the motor while the direct
current lead is connected to the cigarette
lighter socket.
1. Connect the direct current lead (15) to
the socket (7).
2. Connect the direct current lead to the
cigarette lighter socket.
3. The charging indicator (6) flashes
several times, and the battery charges
up.
The charging indicator shows the
condition of the battery continually
(red = 0-50 %, green = 50-100 %).
Charging is stopped automatically
when the battery is fully charged.
Use
Power supply for 12 V appliances.
The start booster can be used as a power
supply for 12 V appliances (max. 10 A). Thus
the total load must not exceed 120 W, as
this will overload and damage the start
booster.
1. Open the 12 V output socket cover (4).
2. Connect the appliance to be supplied
with 12 V DC to the output socket using
the DC lead.
The position of the on/off switch (10) is
not important.
Jump starting
The start booster can be used as a jump
starter for a car or boat whose battery is
partly discharged.
The start booster is not suitable as a jump
starter if the other battery is totally flat.
Handle the battery clips one at a time to
avoid short-circuiting. Always leave the
battery clips in place on the start booster
when they are not in use.
If the battery clips are fitted with the wrong
polarity, the indicator lamp (8) will show red.
Newer cars are often equipped with many
electronic modules (e.g. ABS brakes, fuel
injection, motor control, GPS, mobile
phones), which may be damaged by the
high start voltage and voltage peaks.
Always read the instruction manual of the
car, and possibly the instructions for the
equipment before using the start booster.
1. Check that the engine ignition lock is in
the OFF position.
2. Connect the red battery clip (1) to the
battery's positive (+) terminal.
3. Connect the black battery clip (3) to
the CHASSIS (the motor itself or the car
body) as far away from the battery as
possible.
The indicator lamp (8) will show green if
the connection is correct.
4. Turn on the start booster by turning the
on/off button (10) to the ON position.
5. Turn the engine ignition lock to ON.
Do not start the engine yet.
6. Wait about five minutes.
7. Start the engine.
Do not keep the ignition in the START
position for more than 5-6 seconds at
a time.
8. If the motor does not start: Wait at least
three minutes, and then repeat the
procedure.
9. When the motor is running, turn off
the start booster by turning the on/off
button (10) to the OFF position.
10. Remove the black battery clip first.
11. Replace it on the start booster.
12. Then remove the red battery clip.
DK
NO
SE
FI
GB
DE
PL
ET
33