Faqs - Bmz Power2Go Work Bedienungsanleitung

9.2 POWER2GO 's control elements, plugs and sockets, etc., must not be modified, and
replacement should only be carried out by authorized personnel.
9.3 It is forbidden to touch the electrical contacts of POWER2GO with your fingers, tools, or
other objects.
9.4 POWER2GO cannot be used as an alternative for work benches.
9.5 The shell of the POWER2GO cannot be immersed in water or mud.
9.6 If the battery catches fire, sand is best used to extinguish the fire. If possible, dump the
POWER2GO completely into any water container. The fire brigade respondent must be
notified and informed that the product has lithium-ion battery on it.
9.7 If the POWER2GO is damaged or not properly used, steam may escape. The steam can
irritate the respiratory tract, in which case fresh air must be supplied, please go to well-
ventilated area. If you have any adverse reactions, seek medical attention immediately.
9.8 POWER2GO must not be stored at temperatures higher than 60°C and must be kept
away from heat sources (e.g. heaters, heaters, fire).
9.9 POWER2GO must not be stored or used in places where there is a risk of explosion and
must not be moved using cranes or other lifting equipment to avoid unwanted incidents.
9.10 To prevent injury from tipping over or falling of the POWER2GO , the stable positioning
of the POWER2GO must be ensured in the case of a connected load, and the load
connected to the POWER2GO must be ensured to have sufficient cable length.
9.11 The POWER2GO can only be charged using the included charging cable. Alternatively,
cables of the same design can be used, and if you have any doubts in this regard,
consult an electrical specialist or BMZ. It is forbidden to use the power cord when it is
defective or the insulation is damaged, and protect the power cord from being crushed,
knotted, or damaged by other reasons. Special attention is paid to the fact that the power
plug and charging cable for the POWER2GO can be sourced directly from BMZ.
9.12 Before turning on POWER2GO , you must make sure that the connected load is turned
off.
9.13 POWER2GO must not be used to operate life-sustaining medical device type loads.
9.14 POWER2GO cannot be jet cleaned directly with water, especially pressure washers are
not allowed.
9.15 POWER2GO must avoid contact with chemicals, fuels, and lubricants.
9.16 The operation of POWER2GO should always be monitored by experienced users,
especially minors or people with disabilities are not recommended to use POWER2GO .

FAQs

10.
Q1：How long does it take to fully charge?
⚫
A：A full charge takes around less than 4 hours.
⚫ Q2：Why can't POWER2GO be fully charged?
A：Perform calibration process by fully charging and discharging the device.
⚫ Q3：Why does POWER2GO shut down automatically?
A：1）The battery needs to be charged.
2）If the AC and DC power switches are turned ON, but there is no input and output
EN
for 30 minutes, the POWER2GO will automatically shut down and enter the low-
EN
11